Setting the switch points of an electronic pressure switch for a credit card applicatoin in the vacuum range isn’t a self-explanatory task. The following article therefore explains what must be taken into account with this setting. It involves a pressure switch with a hysteresis function. Instruments with this configuration are most frequently installed in industrial applications.
Electronic pressure switches, such as the WIKA models PSD-4 and PSD-4-ECO or the A-1200 pressure sensor with IO-Link, operate as ?normally closed? or ?normally Increase ?, with regards to the task. The next graphics illustrate both switching functions with the respective switch and reset points:
In principle, the following applies: The switch point (SP) is greater than the reset point (RP) and the beginning of measuring range (MRS) is always smaller compared to the end of measuring range (MRE). This rule can be easily understood with settings for ambient air pressures.
Example: Control of vacuum pressure pump
Alternatively, setting the switch points in the vacuum range and thus, ultimately, the switching function, requires more attention. To illustrate this, let?s take the control of a vacuum pump, for example, which must maintain a vacuum between -0.7 bar and -0.5 bar. For the duty described, we select a pressure switch with a measuring selection of -1 ? 0 bar.
The beginning of measuring range (MRS) is therefore -1 bar, the finish of measuring range (MRE) 0 bar. This implies: At 0 bar (= start of operation) the switch should be closed, as a way to switch on the vacuum pump. If the pressure drops to -0.7 bar, the switch must open and prevent the pump. When the pressure reaches top of the limit value of -0.5 bar, the pump should once again start and run until the pressure has again dropped to -0.7 bar.
ow must the switch points be set within this vacuum range? Let?s take the two pictures and translate MRS and MRE:
Here it really is clear that the ?normally open? function must be selected, otherwise the pump would not switch on. After entering the switch points, the schematic is obtained, which shows the way the pressure switch functions relative to the example:
Note
Information regarding WIKA?s electronic pressure switches can be found on the WIKA website. Would you like to buy pressure switches? Inside our WIKA online-shop you will discover a few of our standard designs. When you have any questions, your contact will gladly assist you to.
Also read our posts
What is meant by the switching function ?hysteresis? with electronic pressure switches?
What is the difference between the switching functions ?hysteresis? and ?window? in pressure switches?
What’ Dynamic meant by the ?normally open? switching function with pressure switches?g